Kenwood TS-590S instruction manual 02%,/%5$&.7, 35&$87,216

,167$//,1*237,216

0%02%,/(%5$&.(7

ATTENTION: When installing the MB-430, use the SEMS Screws provided with the TS-590S.

When installing the MB-430, attach the supplied plastic spacers to the transceiver in advance. This is necessary to protect the TS-590S transceiver from scratches.

Plastic spacers

Make sure the tab faces out

Once the bracket is installed onto the vehicle, prepare the transceiver by loosely screwing in the rear screws. Hook those screws onto the rear guide rail of the mounting bracket then adjust the transceiver to your desired angle before tightening the screws. Insert and tighten the front screws to secure the transceiver in place.

Front screw

Rear screw

To remove the transceiver from the bracket, first remove the front screws, then loosen the rear screws slightly and pull the transceiver forward to unlatch it from the bracket.

Do not install the transceiver so that it is vertically on its side.

35(&$87,216

•When operating mobile, do not attempt to configure the transceiver while driving; it is too dangerous.

•Use of the transceiver while you are driving may be against traffic laws. Please check and observe the vehicle regulations in your area.

73