A-61070 September 1999 5-19
7. Swing the vertical transpor t plate closed and rotate the release
handle 180° counterclockwise (so the red arrow aligns with the red
rectangle) to latch the plate.
Red arrow
Red rectangle
8. Close the side access door.
9. Release and lower the horizontal transport plate back into its
original position.
10. Lower the release bar and latch the front scan module into its
original position.
11. Close the lower access door.
12. Close the upper access door.
13. Locate and grasp the end of the front imaging guide. Carefully slide
the imaging guide out of its track.
14. Locate and grasp the end of the rear imaging guide. Carefully slide
the imaging guide out of its track.
15. Grasp and hold the new rear imaging guide by the green handle
and carefully slide it into place. Make sure the grooves fully engage
the track.
16. Grasp and hold the new front imaging guide by the green handle
and carefully slide it into place. Make sure the grooves fully engage
the track.
NOTE: The imaging guides are not interchangeable. They can
only be inserted one way.
17. Close the right-side access door.