8-6 A-61070 September 1999
Enabling bar
code reading Make sure that Bar Code Reading is enabled before feeding
documents.
To enable Bar Code Reading at the mode level:
• Enter function code F60.
If you have enabled the Bar Code Reader, but do not want to
read/decode bar code(s) found on the next document only, perform
function code F64.
Enabling the bar
code confirmation
tone
The bar code confirmation tone may be used to signal that a bar code
has been read.
• If your machine is configured for no confirmation t ones, t hen no
confirmation tones of any kind will be heard in any mode.
• If your machine is configured to allow confirmation tones, then you
can disable (or enable) confirmation tones in any mode as desired.
If the machine confirmation tones and the bar code confirmation
tone are enabled during installation for the mode being used, you
may enable/disable the bar code confirmation tone during normal
operations by performing function code F63.
In addition, a bar code/patch code confirmation tone may be used to
signal that both a bar code and a patch have been detected. This
confirmation tone may be enabled or disabled by performing
function code F62.
NOTE: Patch Code Reading must be enabled in the scanner in
order to use this feature.