User Guide KODAK DP2900 Digital Projector
Starting the Projector
We recommend using a surge protector power strip when connecting your projector.
&DXWLRQ $OZD\VXVHWKHSRZHUFRUGWKDWVKLSSHGZLWKWKH
SURMHFWRU
1.Remove the lens cap.
2.Plug the power cord into the side of the projector, then plug it into your electrical outlet.
The fans start to run, and the Lamp LED on the top of the projector lights orange until the software has initialized. When initialization is complete, the Lamp LED lights green. A green
Lamp LED indicates that you can press the lamp on/off button 
to turn the lamp on and off.
Note: The first time you connect your computer to the projector, the computer may display a message stating that new hardware was found. The Add New Hardware Wizard may appear. Use the Wizard to load the correct driver (the computer considers the projector a Plug and Play Monitor).
3.Turn on the lamp by pressing the lamp on/off button 
on the keypad.
The startup screen appears.
4.If you connected a video source, turn it on.
The video image should display on the projection screen. If a
computer source is active, press the source button 
on the
keypad (page 30) or press the video button 
on the remote to display your video image. You can select a default source to
determine which source the projector examines first during
Use the volume buttons 
to adjust the volume.
22
