Kodak DRHD-120 manual Additional Information, AdditionalInformation, Problem, Solution, volume

Models: DRHD-120

1 43
Download 43 pages 33.53 Kb
Page 42
Image 42
volume.

AdditionalInformation

Problem

Solution

 

• The remote control is too far from the player, or the angle with the remote

The remote control doesn't seem to

sensor is too wide.

work.

Use the remote within its operating range.

 

• The batteries are exhausted. Put in new batteries.

 

 

 

Some DVD discs do not output digital audio.

 

• Switch your amplifier to the player's analog outputs.

 

Dirt, dust, etc. on the disc.

 

• Clean the disc.

 

Interconnects are not fully inserted into the terminals (or are not connected).

 

• Check that all interconnects are firmly inserted.

 

Dirty or oxidized plugs/terminals.

 

• Clean the plugs/terminals.

No audio, or audio is distorted.

Incorrect audio cable connection.

 

• Check the audio connections.

 

Player's output is connected to the amplifier's phono (turntable) inputs.

 

• Connect to any set of inputs except phono.

 

The disc is paused.

 

• Press (play) to exit the pause mode.

 

Incorrect amplifier settings.

 

• Check that the volume is turned up ,that the speakers are on, the input function

 

set correctly, etc.

 

 

 

Incorrect Audio menu settings.

The analog audio is OK, but there

• Make sure that the Digital Audio Out setting is set to PCM or Bitstream.

appears to be no digital audio signal.

Check that the PCM or Bitstream settings are suitable for your amplifier

 

-check the amp’s instruction manual.

 

 

Noticeable difference in DVD and CD

• DVDs and CDs use different recording methods. This is not a malfunction.

volume.

 

 

 

 

• If this unit is connected to a non-DTS compatible amplifier or decoder using a

 

digital audio cable, please connect to a DTS compatible amplifier or decoder.

No DTS audio output.

If you do not do this, noise will be output if you try and play a DTS disc.

• If this unit is connected to a DTS-compatible amplifier or decoder using a

 

 

digital audio cable, check the amplifier settings, and that the cable is properly

 

connected.

 

 

NOTE

Static electricity or other external influences may cause malfunctioning of this unit. In this case, unplug the power cord and then plug back in. This will usually reset the unit for proper operation. If this does not correct the problem, please consult your nearest service center.

42 42  Additional Information Additional Information

Page 42
Image 42
Kodak DRHD-120 manual Additional Information, AdditionalInformation, Problem, Solution, volume