Kodak DX6440 manual Picture is not Lens is dirty Clean the lens Clear, Taking picture

Chapter 10

Problem	Cause	Solution
Picture is not	The lens is dirty.	Clean the lens (page 107).
clear.
	Subject too close when	Move so there is at least 19.7 in.
	taking picture.	(50 cm) between the camera and
		the subject, or at least 3.9 in. (10
		cm) at Wide in Close-up mode.
	Subject or the camera	Place the camera on a flat, steady
	moved while the	surface or use a tripod.
	picture was taken.
	The subject is too far	Move so there is no more than
	away for the flash to be	16.7 ft (5.1 m) between the
	effective.	camera and the subject; 8.5 ft
		(2.6 m) in Telephoto.
	Auto focus was not	To take the best possible pictures,
	achieved.	press the Shutter button
		half-way and hold. When the
		ready light glows green, press the
		Shutter button the rest of the
		way down to take the picture. (If
		the yellow light blinks, release the
		Shutter button and recompose
		picture.)
Slide show does	Video Out setting is	Adjust the camera Video Out
not run on	incorrect.	setting (NTSC or PAL,
external video		page 67).
device.
	External device is set	See the external device’s user’s
	incorrectly.	guide.
Camera freezes	Camera detected an	Turn the camera off, then back on.
up when a card is	error when the card	Make sure the camera is turned off
inserted or	was inserted or	before inserting or removing a
removed.	removed.	card.

89