Kodak DX6440 Light Subject was too, Close for flash, Between camera and subject, Light sensor is

Chapter 10

Problem	Cause	Solution
Picture is too	The flash is not needed.	Change to Auto flash or Flash Off
light.		(page 24).
	The subject was too	Move so there is at least 1.6 ft (0.5
	close for flash.	m) in Wide; 2.5 ft (0.75 m) in Tele
		between camera and subject.
	The light sensor is	Hold the camera so your hands or
	covered.	other objects do not cover the light
		sensor.
	Too much light.	Decrease Exposure Compensation
		(page 30).
	Auto exposure was not	To take the best possible pictures,
	achieved.	press the Shutter button
		half-way and hold. When the
		ready light glows green, press the
		Shutter button the rest of the
		way down to take the picture.
In Review mode,	The picture has no	Transfer the picture to the
a blue screen is	thumbnail or an	computer (page 73), or delete the
displayed instead	unrecognized	picture (page 51).
of a picture.	thumbnail.
Stored pictures	The card was removed	Make sure the ready light is not
are damaged.	when the ready light	blinking before removing the card.
	was blinking.

88