Kohler 1199249-2-A manual Troubleshooting, Exceptions and Restrictions

Warranty (cont.)

replacement or an equivalent model (in those cases that the model has been discontinued) when the product is beyond repair, without any charge to the consumer.

4.The time of repair will not exceed six (6) weeks commencing on the date the product is received.

5.It is recommended that the consumer save the invoice or receipt as additional protection, as it may substitute the warranty in the case that there is a discrepancy in the validity of the warranty.

EXCEPTIONS AND RESTRICTIONS

The Warranty will not be valid in the following cases:

1.When the product is not operated in accordance with the instructions concerning use and operation set forth in the owner’s manual or installation instructions, and when the recommendations and warnings included are not observed.

2.When the product has been modified or dismantled partially or totally; or has been used in a negligent fashion and as a consequence has suffered damages attributable to the consumer, individual, or hardware not authorized by Kohler Co.

3.This warranty does not cover the damages as a result of disaster such as fire or acts of God, including flooding, earthquake, or electric storms, etc. To obtain a list of distributors in your area where you can exercise your rights under this warranty, please call 001-800-456-4537.

KOHLER CO., KOHLER, WI 53044 U.S.A.

IMPORTER:

INTERNACIONAL DE CERÁMICA, S.A.B. DE C.V.

AV. CARLOS PACHECO NO. 7200

CHIHUAHUA, CHIH., MEXICO C.P. 31060

TEL: 52 (14) 29-11-11

Troubleshooting

NOTICE: This section is for general aid only. A Kohler Co. Authorized Service Representative or qualified electrician should correct any electrical problems. For warranty service, call 1-800-4KOHLER from within the USA and Canada, or 001-800-456-4537 from within Mexico.

NOTE: The product model number is printed on a label on the blower side of the bath.

NOTE: For service parts information, visit your product page at www.kohler.com/serviceparts.

Troubleshooting the Bath System

Symptoms	Probable Causes		Recommended Action
1. User keypad does not	A.	No power to control.	A.	Check wiring and connect power.
illuminate when Power	B.	Ground-Fault Circuit-Interrupter	B.	Reset GFCI or RCD. If it trips
icon is pressed or the		(GFCI) or Residual Current		again, refer to ″Ground-Fault
outer ring is rotated.		Device (RCD) tripped.		Circuit-Interrupter (GFCI) or
				Residual Current Device (RCD)
				trips when bath is turned on.″
	C.	Wiring harness from user	C.	Check wiring for proper
		keypad to control is loose,		connections. Replace the wiring
		disconnected or damaged.		harness if necessary.
	D. User keypad does not work.		D. Replace the user keypad.
	E.	Control does not work.	E.	Replace the control.

1199249-2-A 18 Kohler Co.