Section 1 Introduction
Information in this publication represents data available at the time of print. Kohler Co. reserves the right to change this publication and the products represented without notice and without any obligation or liability whatsoever.
x:in:001:002:a
The safe and successful operation of a marine power system depends primarily on the installation. See Figure
marine generator set. For operating instructions, refer to the operation manual.
Marine generator set installations must comply with all applicable regulations and standards.
Use the specification sheets as a guide in planning your installation. Use current dimension drawings and wiring diagrams.
1 2
17
16
3
15
14
KOHLER
4
| 5 |
| 13 |
| 9 |
| 8 |
12 | 6 |
11 | 7 |
| 10 |
585711
1.Exhaust mixer elbow (exhaust/water outlet) (not shown)
2.Heat exchanger (not shown)
3.Coolant recovery tank (located on the unit on some models)
4.Seawater strainer *
5.Seawater pump (seawater inlet)
6.Seawater line *
7.Seacock *
8.Craft stringers
9.Fuel feed pump (fuel inlet) *
10.Fuel return line *
11.Hose clamps
12.Fuel supply line *
13.Mounting tray (mounting skid on
14.Battery/battery storage box
15.Battery cables
16.Exhaust hose or exhaust line *
17.Electrical leads (AC output leads/remote start panel leads)
*Indicated components must conform to USCG regulations.
Figure 1-1 Typical Generator Set Location and Mounting
Note: See text for complete explanation of installation requirements.
Note: Use two hose clamps on each end of all flexible exhaust hose connections.
Section 1 Introduction | 1 |
