8.Determine the direction of the incoming water supply: falling (entering the shower from the top), or rising (entering the shower from the bottom).
Do not use an incoming supply entering the shower directly from the back. Add an elbow to the supply pipe and connect it as a rising or falling supply.
9.Rotate the inlet connector to suit the direction of the incoming water supply.
10.The case has thinned sections that can be removed to allow entry of the supply pipe and electrical cables. Remove the top thinned section of the case for a falling supply, or remove the bottom thinned section of the service tunnel for a rising supply.
11.Do not remove any case if the electrical cables enter from the back.
Inlet Connector
Thinned
Section
Service Tunnel
Thinned
Section
17
