Replacing All Toner Cartridges at the Same Time
Note
Be careful not to spill toner while replacing a toner cartridge. If toner spills, immediately wipe it off with a soft, dry cloth.
By using the Eject All Toner mode, all toner cartridges can be replaced at the same time.
Follow the procedure described below to use the Eject All Toner mode.
1 Use either operation described below to switch the printer to Eject All Toner mode.
zHold down the Rotate Toner key for more than 10 seconds.
zOn the Panel tab of the Remote Panel Utility, select Eject All Toner, and then click the Rotate Toner button.
" The printer enters Eject All Toner mode, and the magenta toner indicator lights up.
" To exit Eject All Toner mode, press the Clear key.
2 Perform the operations described in steps 3 through 11 of “Replacing a Toner Cartridge” on page
3 Follow the same procedure to replace the cartridges for the cyan, black, then yellow toners.
4 Press the Clear key to reset the printer and clear the indicator message.
" The printer must complete a calibration cycle (less than 2 minutes) after a toner cartridge has been replaced. If you open the top or front cover before the printer is reset, the calibration stops, then starts over again after the cover is closed.
Replacing Consumables |