9. Storing settings to the [PROGRAM MEMORY] keys

You can store your favorite settings to the [PROGRAM MEMORY 1–8] keys, and instantly recall those settings when desired.

Settings that can be stored

•Effect program

•[HOLD] key on/off status and position (coordinates)

•[FX BALANCE] knob setting

•For the “BPM FX” group, the specified BPM value

•For the “SAMPLE/PLAY” group, the [SAMPLE 1] and [SAMPLE 2] keys used

•Pad motion

Audio effect programs 60 and 90–99 do not store the state of the [HOLD] key.

Storing

1.Use the [PROGRAM/BPM] knob to select the effect program you want to assign.

If you want to store the state of the [HOLD] key, select the program, then turn the [HOLD] key on and touch the touch-pad to specify the position. Also make any other settings that you want to store.

2.While holding down the [FUNCTION] key, hold down the [PROGRAM MEMORY 1–8] key that you want to assign for approximately two seconds; the settings will be stored.

When the settings have been stored, the [PROGRAM/BPM] display will stop blinking.

If you hold the [PAD MOTION / MUTE/ FREEZE] lever at PAD MOTION while storing the settings, the pad motion will not be stored.

Recalling

1.Press one of the [PROGRAM MEMORY 1–8] keys to recall the program and settings that were stored in that key. If you hold the [PAD MOTION / MUTE/FREEZE] lever at PAD MOTION while recalling the settings, the pad motion will not be recalled.

10. Creating a COMBI program

About COMBI

By setting the [CONTROL SELECT] switch to [COMBI] and operating the touch-pad, you can simultaneously control video effects and audio effects.

To store a COMBI

1.Set the [CONTROL SELECT] switch to [AUDIO], and select a program.

2.Set the [CONTROL SELECT] switch to [VIDEO], and select a program.

3.Set the [CONTROL SELECT] switch to [COMBI], and while you hold down the [FUNCTION] key, hold down the desired [PROGRAM MEMORY] key for approximately two seconds to store the settings.

11.Sampling and playing a still

image

By moving the [PAD MOTION / MUTE/FREEZE] lever to MUTE/FREEZE you can freeze the video that is being output, store the still image in the [SAMPLE 1] or [SAMPLE 2] key, and then use the touch-pad to control the still image (for example by expanding or inverting it). You can store one still image in each of the two keys.

The sampled images will be lost when you turn off the power. It is not possible to save the sampled images.

Sampling

1.Set the [PAD MOTION / MUTE/FREEZE] lever to MUTE/FREEZE.

The monitor image will freeze.

2.Press either the [SAMPLE 1] or [SAMPLE 2] key.

The still image shown in the monitor will be stored to the key you press.

Playback

1.When you press the [SAMPLE 1] or [SAMPLE 2] key, the sampled still image will be selected as the input source.

While playing back the still image, you can operate the touch-pad to apply an effect to the still image.

Press the [SAMPLE 1] or [SAMPLE 2] key once again to cancel the still image playback.

Some effects may not produce any result.

If you have selected a program from other than the “SAMPLE/PLAY” group, you cannot play back the still image except while recording.

8