Operation

1.Turning on the power

1.Connect your equipment as described in the connection examples, and plug the AC adaptor into an AC outlet.

2.Press the [STANDBY] switch to turn on the power. The [PROGRAM/BPM] display will light.

An image will appear on the connected TV monitor.

To turn off the power

Press the [STANDBY] switch once again.

2.Checking the video input

1.Output a video signal from a connected device.

2.Use the [VIDEO SELECT] switch to select the input jack that is receiving the video signal you want to process.

1:The effect will apply to video input 1.

2:The effect will apply to video input 2 (or

S-video input 2). The [VIDEO 2] indicator will light.

If no signal is being input to video input 2, the [VIDEO 2] indicator will blink.

S-video input 2 takes priority for video input 2.

3.Adjusting the volume

1.Output audio from a connected device.

2.Adjust the audio input level.

Use the [LINE INPUT VOLUME] knob to adjust the input level so that the peak indicator does not light red.

If you are using headphones

Use the [PHONES VOLUME] knob to adjust the volume.

4.Selecting a program

1.Use the [CONTROL SELECT] switch to select the signal (video, audio) that you want to process with the effect.

Use the left position to apply effects to the audio, or the right position to apply effects to the video. If you select COMBI (center

position), effects will be applied to both audio and video.

Refer to “Creating a COMBI program”

2.The [PROGRAM/BPM] display shows the number of the currently selected program. Use the [PROGRAM/BPM] knob to select a program (00–99).

3.Use the [FX BALANCE] knob to adjust the effect depth.

Turning this knob to the far left will lessen the effect; turning it to the far right will produce the maximum effect.

The result will depend on the effect you select.

If this knob is set to the far left, no effect will be applied to the sound (“dry”); if the knob is set to the far right, the maximum effect will be applied (“wet”).

If you want to use the [FX BALANCE] knob to adjust the effect depth, set the [CONNECTION] switch to DIRECT.

About the [PROGRAM/BPM] display

This shows the number of the currently selected program, the specified BPM, and the position of the point at which you touch the touch-pad.

When you touch the touch-pad: The position you touched (1.1–9.9; 5.5 is center) is displayed.

Vertical position (1–9)

Horizontal position (1–9)

When you switch programs: The display shows the program number (00–99). In Combination mode, this may indicate (--) for some settings when you use the program memory keys to recall a program.

When you set the BPM: When you use the [TAP/BPM] key to set the BPM, the display shows the BPM value. In Auto BPM mode, three dots will light.

In Pattern Select mode: The display shows the number of the currently selected pattern.

In MIDI Edit mode: The display shows information such as the MIDI channel or control number.

5. Using the touch-pad

1.Rub your finger over the touch-pad or tap (lightly strike) it to control the effect (sound).

Affix the included protective sheet to the pad to help protect it.

2.If you turn on the [HOLD] key, the effect (sound) for the position immediately before you removed your finger from the touch pad will be maintained.

6