FAQ

Q1: A video effect is not applied when I touch the pad

A: Check the following points.

1)Is the control lever in the correct position? >> The video effect is applied only when the

control lever is in the COMBI or VIDEO mode.

2)Try adjusting the FX BALANCE knob.

>> The FX BALANCE knob adjusts the video only if the control lever is set to VIDEO.

3)Is the PAL/NTSC switch in the correct

position?

>>You must turn off the power before changing the position of this switch.

Q2: I can't sample a still image successfully.

A: In order to sample a still image, the control lever must be in VIDEO mode.

>>Set the control lever to VIDEO mode. Then use the MUTE/FREEZE lever to freeze the image and press the SAMPLE (1 or 2) button to sample the image.

Q3: In COMBI mode, the VIDEO effect applies only to still images.

A: If a still image is being played back, the video effect will apply to the still image.

>>To stop playback of the still image, temporarily set the control lever to VIDEO, and then press the SAMPLE button to stop the still image playback.

Q4: In COMBI mode, turning the FX BALANCE knob does not change the video effect.

A:In COMBI mode, the FX BALANCE knob applies only to the audio effect.

Q5: I want to store video effect and graphic pattern playback together in memory.

A:You can't store an effect program and graphic pattern playback together in the PROGRAM MEMORY 1–8 keys.

Q6: The graphic pattern disappears when I change the video effect.

A:Graphic pattern playback will stop when you re-select the effect program.

>>If you want to display the pattern again, you must re-enter graphic pattern mode.

If you want to apply a video effect to the pattern, first select the desired video effect, and then enter graphic pattern mode and select the pattern.

Q7: Can I mix the two video inputs VIDEO 1 and VIDEO 2?

A:The KAOSS Pad KAOSS PAD Entrancer does not have input mixing capability.

>>The video effect program applies to the input you select; either VIDEO 1 or VIDEO 2. However, you can operate the input select switch to obtain a result similar to mixing a sampled video clip or still image.

About demo mode

Entering demo mode

Set the control lever to COMBI and hold down the FUNCTION key while you turn on the power. (The FUNCTION key will light momentarily.)

Using demo mode

When the control lever is set to COMBI and you do not perform any operation for five seconds, the demo will start. (Pad motions will be automatically executed as the demo mode advances through the COMBI programs.) Only the COMBIs will be demoed. Sampling programs (94–99) will be skipped.

Pausing demo mode

The KAOSS PAD Entrancer will pause the demo mode when you perform any operation, and will re-enter the demo mode if no further operation has been performed for five seconds.

Exiting demo mode

Turn off the power, and then turn it on again in the usual way.

13