Kramer Electronics FC-5 user manual Transmitting Commands via the Relays

6.3Transmitting Commands via the Relays

You can use your FC-5to transmit commands via the relays:

Figure 15: Transmitting Commands via the Relays

A PC or Remote Controller is connected to the COM1 port. Relay 1 is connected to the blinds, and relay 2 is connected to the lighting system. On each 3-pole terminal block connector, connect either: C to NO, or C to NC

Figure 16: Relay Pinout

C

NO

NC

Common

Normally Open (that is, the electricity is switched ON)

Normally Closed (that is, the electricity is switched OFF)

16 FC-5 - Using the FC-5