1 Get Started

Phone Battery

Install the Battery

1.With the back of the phone facing you, press on the back cover and slide it to the bottom of the phone.

2.Lift the back cover from the bottom to remove.

3.Place the battery in the phone casing with the metal contacts toward the top of the phone.

4.Align the back cover side tabs with the slots on each side of the phone.

5.Slide the back cover to the top of the phone until it is securely in place.

Note: Before removing the battery, make sure to power off the phone.

Charge the Battery

You must have at least a partial charge in the battery to make or receive calls.

To charge the battery:

1. Remove the rubber

USB cover and connect

the AC adapter to the microUSB jack on the

side of the phone.

2. Plug the adapter into a wall outlet.

The battery icon in the upper-right corner of the screen shows whether the phone is:

Charging (animated icon)

Partially charged

Fully charged

You can safely recharge the battery at any time, even if it has a partial charge.

Warning: The battery does not charge if you use the phone while it is connected to an AC adapter.

User Guide

9

Page 9
Image 9
Kyocera G2GO manual Get Started, Phone Battery, Install the Battery, Charge the Battery