46 Customizing Your Phone

Erasing all contacts

You can erase all entries in your Contacts directory.
1. Select Menu → Settings → Security.
2. Enter your four-digit lock code.
3. Select Erase Contacts.
4. Select Yes to erase all contacts. A message
appears: “Erase ALL Contacts?”
5. Select Yes again to erase all conta cts.
Network settings

Switching between phone lines

Your phone can have two service accounts, or
phone lines, associated with it. Each phone line has
its own phone number. You must first establish a
second phone line with Alltel. Once established, a
second phone number becomes available in the
menu for selection.
Note: Not available on all phones, check with Alltel.
When you are using one line, you cannot receive
calls from the other. It would be as if the phone
were “off” for that number. Your voicemail,
however, will still take messages. All contacts and
settings are shared for both lines.
1. Select Menu → Settings → Network →
SetPhone Line.
2. Select one of the two lines and press .
Data Settings

Setting Com port speed

The Com Speed sets the data rate at which your
phone connects to a laptop or personal computer
or at which it sends and receives over-the-air
textmessages.
Note: Not available on all phones, check with Alltel.
1. Select Menu → Settings → Accessories →
ComPort Speed.
2. Select the speed: 19.2 kbps, 115.2 kbps
(default), 230.4kbps, or Other.
Note: There may be a higher charge for making
calls using high-speed data in areas where 1X
service is available. Check with Alltel for details.

Setting the phone to receive data

orfaxes

Your phone may be able to receive certain data or
faxes, depending on the system sending the
information. You cannot receive voice or T2T calls
while the phone is in data/fax mode. To receive data
or faxes, you must connect the phone to a laptop or
PC and switch the phone from voice mode to
data/faxmode.
Note: To purchase a data cable call 800-349-4188
(U.S.A. only), 858-882-1410, or visit
www.kyocera-wireless.com/store.
82-N8190-1EN.book Page 46 Friday, January 27, 2006 11:09 AM