LANIER 1/3rd Scale Laser 200 ARF -IN STRU CTIONS
© 2002 Lanier R/CPage-2
BUILDING INSTRUCTIONS
Beforestarting to build this kit, we urge you to read
through these instructions thoroughly. They contain
som e important building sequences as well as
instructions and warnings concerning the assem bly
and use of the model.
BUILDING SUPPLIES NEEDED
Hobby knife w/ #11 blade
Medium Zap CA
30 Minute Z-poxy
Wire cutters
Pliers
Drill with bits: 1/32”, 1/16”, 1/8”, 5/32”, ¼”
See the list at the end of the instruction book for a
list of additional R/C equipm ent you w ill need to
com plete the 1/3rd La ser.
1. Locate (10) hinge points.
2. Use the picture as a guide to find the (5) holes in
each aileron and each side of the wing. Test fit a
hinge in each hole.
3. Put a small drop of oil on each hinge, then use 30
minute epoxy on each hinge and hole. Press the
ailerons in place, leaving a 1/32” gap at the hinge
line, then wipe off any excess epoxy off with
alcohol and a paper towel.
4. A t the two locations on the wing, rem ove the
covering from the hole to install your aileron
servo.
5. M ark the location of the aileron servo plate rails
on the inside of the plywood servo plate (aprox.
3/8”). Remove the covering from the hole for
the servo arm.
6. Position your aileron servos and the hardwood
blocks on the plates and mark the position.
7. G lue the blocks in place on the plates with 30
minute epoxy.
8. W hen cured, replace the servo and drill 1/32”
pilot holes for the servo screw s included with the