LANIER – 1/3rd Scale Laser 200 ARF -IN STRU CTIONS
© 2002 Lanier R/CPage-4
15. U sing a sharp hobby blade, cut the covering
aw ay from the wing tube and locating pin holes.
You may want to seal the covering down with
CA or a sealing iron.
16. T est fit the wing tube through the fuselage. Use
a ruler to help center the tube in the fuse , then
mark the alignm ent with a perm anent marker.
17. T em porarily mount the wing on the wing tube,
sliding the dowels in the locator holes. Be
careful to keep the tube centered in the fuse.
18. L ocate the (2) 6-32 x 1” bolts. With the wings
tight against the fus e, Drill (2) 0.1” holes
through the aluminum tube.
19. Use a 6-32 tap to thread the holes in the tube.
20.C ounter sink the hard points 1/8” deep with a
1/4”drill bit. Work carefully to keep the w ood
from splitting.
21. T est fit the bolts in the holes. Put thread lock on
one bolt and cover the bolt hole with 3m vinyl
tape. L eave this bolt in place perm anently.
22. W hen ready for flying, put 3M clear vinyl tape
over the other bolt.