Lantronix XSENSO 21R2 manual To Configure DAQ Settings, Analog Input, Output and Relay Settings

9: Analog Input, Output and Relay Settings

Command (continued)	Description	Example		xSenso Model
AOUT2 <value>	Writes Output 2 value.	AOUT2 +10.0\r		xSenso 21A2
	Value must have float format:	SUBMITTED
	[+/-]<digits>.<digits>
ROUT1	Reads Relay 1 current setting.	ROUT1\r		xSenso 21R2
		+1
ROUT2	Reads Relay 2 current setting.	ROUT2\r		xSenso 21R2
		+0
ROUT*	Reads all current relay settings.	ROUT*\r		xSenso 21R2
		+1	+0
ROUT1 <0, 1, or 2>	Write Relay 1 setting:	ROUT1 1\r		xSenso 21R2
	 0 to turn off relay	SUBMITTED
	 1 to turn on relay
	 2 to reset latched relay
ROUT2 <0, 1, or 2>	Write Relay 2 setting:	ROUT2 0\r		xSenso 21R2
	 0 to turn off relay	SUBMITTED
	 1 to turn on relay
	 2 to reset latched relay

	Table 9-3 DAQ Settings
DAQ Settings	Description
Time Type	Select Uptime or Clock time type. If Timestamp is enabled, this selection applies.
	Uptime represents the time since the device has powered up. To use Clock time,
	first go to Clock settings to set it up.
Timestamp	Select whether to enable a time stamp to be placed before each sample value.
Identifier	Select whether to enable an alphanumeric identifier to be placed before each
	sample value and optional timestamp.
Units	Select whether ot enable the applicable unit to be placed after each sample value.
End Character	Enter an end character to place this character at the tail end of sample strings. You
	may also delete field contents to remove the end character.

To Configure DAQ Settings

Using Web Manager

To configure DAQ Settings, go to the Setup tab/page and click DAQ Format in the menu.

Using the CLI

To enter the DAQ Settings command level: enable -> config -> analog -> daqformat

Using XML

 Include in your file: <configgroup name=”daq format”>

xSenso User Guide 54