3: Installation of xSenso
| Table |
|
|
Ethernet LEDs | Description |
Left (L) | GREEN ON - 100 Mbps link established |
| GREEN Blink - 100Mbps activity |
| AMBER ON - 10 Mbps link established |
| AMBER Blink - 10 Mbps activity |
|
|
Right (R) | GREEN ON - Full duplex |
| OFF - Half duplex |
|
|
Reset Button
You can reset the xSenso to factory default settings, including clearing the network settings. The IP address, gateway, and netmask are set to 00s.
To reset the unit to factory defaults:
1.Place the end of a paper clip or similar object into the RST (reset) opening (see Figure
2.Remove the paper clip to release the button. The unit will continue the boot process restoring it back to the original factory default settings.
To reboot the unit without resetting the unit to factory defaults:
1.Place the end of a paper clip or similar object into the RST (reset) opening (see Figure
2.Remove the paper clip to release the button. The unit will reboot.
Right Side Panel
The following are located on the right side panel (Figure
Analog Input 1
Analog Input 2
Note: There are no inputs or outputs on the left side panel.
xSenso User Guide | 25 |