Lennox Hearth 32FS Care And Operation, Start, Simple Operating Instructions, Button, Heat Output

Models: 32FS

1 36
Download 36 pages 24.37 Kb
Page 17
Image 17
CARE AND OPERATION

CARE AND OPERATION

Simple Operating Instructions

1. Start

FIRST TIME USE

2. Preparation

a] Check hopper and remove any materials from hopper and auger

b] CheckUltraGrate™forproper fit (ensure UltraGrate is set securely in the base - see Figure 29)

c] Check door gasket and door latch to ensure tight seal (see Figure 33)

d] Connect power cord to grounded power supply outlet

3.Priming the Auger (Optional)

a] Fill hopper with pellets

Note: use quality grade pellet fuel

b] Push the "START" button to turn on the blowers and auger motor

e] When pellets begin to drop from feed tube into UltraGrate, push the "STOP" button to stop the auger

4.Stove is now ready for start-up

5. To Start Your Stove

a] Push the "START" button.

Simple Operating Instructions Note: Room air blower and exhaust blower start w/ line voltage for 10 seconds, then return to settings when last operated.

6.Pellets will drop into UltraGrate and stove will light in approximately 3 to 7 minutes

Yes

Does the Stove Light?

No

7a.Follow the troubleshooting section in this manual

7.Set stove to desired heat setting (heat output button). The new setting willnottakeeffectuntilthe switch receives adequate heat to activate.

8.After approx. 5 minutes adjust damper if neces- sary to obtain a bright vibrant flame.

Notes:

If the damper is too far inward the flame will be lazy/sooty and the fuel will pile up in the UltraGrate (see Page 9).

If the damper is too far outward the flame might be extinguished because of too much combustion air.

See Page 19 for further instructions on adjusting damper using thermostat vs manual modes.

Heat Output

COMBUSTION

 

 

AIR

Start Button

Button

(-)

(+)

 

 

O

 

HEAT START

Convection OUTPUT (room air)

Blower

Button

BLOWER 1. Start

PELLET

FEED

O

(-) Note: use quality grade pellet fuel (+)

FEEDING Heat Output

STOPButton

Stop Button

Yes

Does the Stove Light?

No

Contact your Lennox Hearth Products dealer for further assistance

9. To Turn Off Pellet Stove

a] Push "STOP" button - stove enters shut down mode

b] Combustion blower goes to highandroomairblowerwill operate at the panel setting untillowtemperatureswitch cools. Pellets stop feeding and the fire goes out in approximately 15 minutes aftertheaugerisshutoff,the roomairblowerandexhaust blower will automatically shut off.

HEARTH PRODUCTS

10.Thank you for purchasing a Lennox Hearth Products Pellet Stove

END

17

Page 17
Image 17
Lennox Hearth 32FS Care And Operation, Start, Simple Operating Instructions, Note use quality grade pellet fuel, Button