INSTALLATION
Removing Appliance From Pallet
1.After removing the packaging from the stove, lift the hopper lid, and remove all prepackaged items that were shipped in the hopper. Next, open the stove door and remove all prepackaged items.
2.With the stove door open, remove the ash drawer and set aside. Using a 7/16” socket or open end wrench, remove the front lag screw (see Figure 5A).
3.Using a 5/32" allen wrench remove the two screws in the rear pallet bracket (see Figure 5B). Using a 7/16” socket or open end wrench, remove the rear lag screw (see Figure 5B).
Pallet |
SEE DETAIL B |
Front Lag Screw |
DETAIL B |
Front Lag Screw |
(actual size) |
Figure 5A - Front Lag Screw |
Pallet |
SEE DETAIL C |
Rear Pallet |
Bracket |
Rear Lag Screw |
Rear Lag Screw |
(actual size) |
DETAIL C |
Figure 5B - Rear Lag Screw and Pallet Bracket |
Installation Check List
It is strongly recommended that you have an Lennox Hearth Products dealer install your stove. If you install your stove yourself, you should review your installation plan with an Lennox Hearth Products dealer.
Check list:
Check off each item as you proceed with the installation process.
qRead the ENTIRE stove installation section first
qDetermine the appropriate measurements and locations for your installation.
qFollow the installation directions in this manual.
qBe sure to prefit all items before you install, fasten, or set up the appliance permanently.
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE