45

To install an easy-swap hard drive:

1Remove the side panel from the chassis. Go to page 37 for instructions.

2Observe steps 2 through 5 of the previous section.

3Connect the easy-swap HDD cables.

(1)Connect the power connectors of the SAS/SATA2 cable to the power supply module HDD power cables.

(2)Connect the data connectors of the SAS/SATA2 cable to the signal connectors of the of the easy-swap HDDs.

(3)Connect the other end of the SAS/SATA2 power cable to the add-on SAS controller card.

4Observe the post-installation instructions described on page 36.

5Set up the new hard drive’s RAID configuration.

For related instructions, go to the “RAID configuration utilities” section on page 110.

Page 63
Image 63
Acer G5450 Series manual To install an easy-swap hard drive