Avaya 38HBK00001SCM manual Install Advantech PCI Wallboard Comms Card, Jumper Settings

PC Configuration Server PC – SPC20 (Max 20 Clients)

Install Advantech PCI Wallboard Comms Card

Before installing the Wallboard Comms card in to the system, you must install the driver first. Once the driver is installed, check the card jumpers and Switch locations are set as detailed in this section.

1.Ensure the card is NOT plugged in to the PC.

2.Insert the Advantech installation diskette #1 into drive A:\.

3.From the Windows NT desktop, click Start and then select Run. In the Open box type A:\Setup.exe.

4.Click OK to proceed. At the Welcome screen click Next. From the Software License Agreement screen click Yes to continue.

5.From Choose Destination Location screen, click Next to continue.

6.From Select Program Folder screen, click Next to continue.

7.When prompted, insert diskette #2 in to drive A:\.

8.Click Finish to complete the Setup, the following screen appears:

9.With Install and Start Service selected, click OK.

10.When the files have been copied, the following screen appears:

11. Click OK.

12 Switch the PC off.

13.Plug the Card in to a free PCI slot with the following Jumper Settings. Switch the PC on.

Jumper Settings:

–Set Jumpers JP1 and JP2 to 485

–Set Channels 1 & 2 Dip Switches to ‘ON’.

After the PC is restarted, reinstall Service Pack 6a as detailed in “Install Windows

NT Server Service Pack 6a” on page 17.

INDeX Contact Centre Modules	Page 28
Installation & Maintenance	38HBK00001SCM - Issue 11 (05/01)