Avaya 38HBK00001SCM manual Wall Mounting, Ceiling Mounting

Wallboard Installation and Maintenance INDeX Wallboard 22

Wall Mounting

Once a location has been decided upon, a pencil may be used through the two holes in the brackets to mark its location onto the wall. Before drilling holes, a suitable utility detector should be used. Once done, the holes may be drilled and the brackets mounted using the relevant fixings provided.

Before mounting the display onto the brackets, the network address should be assigned. The power lead should also be attached prior to mounting.

To mount the display, first hook the bottom of the two brackets into the bottom rear recess channel of the display. See Fig.2.

Fig. 2

Push the wallboard flat against the wall and push upwards to fully locate the bottom half into the recess. Now allow the display to fall approximately one inch. The display should now be safely located onto the two brackets.

To remove a wall mounted display then reverse the above paragraph.

Note

The wallboard position can be adjusted by sliding sideways in either direction.

Ceiling Mounting

Using the mounting kit provided, firstly, drill the 6-mm holes for the eyehole bolts and secure them into the ceiling. Pass the spun wire chain through the eyeholes and through the housing clamps and tighten at the required height.

Remove the right hand end cheek of the wallboard by unscrewing the two fixing screws.

Slide the two nipples on the end of the spun wire chain into the middle groove of the display housing and replace the end cheek. Centre the display on the hanging wires. Adjustments can be made by sliding the display to achieve the final level.

Warning

Ensure the ceiling can support the weight of the wallboard prior to fixing.

INDeX Contact Centre Modules	Page 96
Installation & Maintenance	38HBK00001SCM - Issue 11 (05/01)