Avaya 38HBK00001SCM Serial Connection and Configuration, Dip-switch Number, INDeX Wallboard, Page

Wallboard Installation and Maintenance INDeX Wallboard 10

Serial Connection and Configuration

An RJ45 junction box is provided as standard, alternatively if required an RJ45 coupler and 2 way adapter can be used. The serial cable is normally connected to the logic board for RS485 operation, check label on rear of display for specific configuration. The serial communications lead from the PC is connected to the junction box as shown later in this manual. Modifications to the network numbers and baud rates can be done by following section 2.3 below, but changing the dip- switch settings as per Figure 5.

Fig. 10

1. RS232 Connection 2. RS485 Connection 3.Dip-Switches

Fig. 11

To set the network number requires access to the INDeX Wallboard 10 logic board as explained above and Fig 5.

To address individual displays in a network, a network number can be set on the dip-switch on the logic board. Network 0 is a general address and will accept all data from the host system. The network number is set using switches 1,2,3 and 4.

Dip-switch Number

1	2	3	4	Network
OFF	OFF	OFF	OFF	0
ON	OFF	OFF	OFF	1
OFF	ON	OFF	OFF	2
ON	ON	OFF	OFF	3
OFF	OFF	ON	OFF	4
ON	OFF	ON	OFF	5
OFF	ON	ON	OFF	6
ON	ON	ON	OFF	7
OFF	OFF	OFF	ON	8
ON	OFF	OFF	ON	9
				ETC….

INDeX Contact Centre Modules	Page 104
Installation & Maintenance	38HBK00001SCM - Issue 11 (05/01)