Within a few seconds, the HOME screen appears (see fig- ure 2) with default settings as shown. After about 1 minute of initialization time, the actual room temperature will be displayed.
NOTE − Tables 2 and 3 on page 7 show all system and programming defaults.
HOME Screen
| HOLD |
| MO | I0:26 | |||
|
| PM | |||||
| PROG | AM |
|
|
| ||
| A B C D |
|
|
| |||
|
|
|
|
|
| ||
|
|
|
|
|
|
| |
FAN ON |
|
|
|
|
| ||
AUTO |
|
|
|
| COOL | ||
|
|
|
|
|
| ||
|
|
|
|
|
| OFF | |
|
| ROOM |
| AUTO | |||
70° |
| EMG. | |||||
|
| ||||||
| HEAT |
| |||||
|
|
| |||||
|
|
|
|
|
|
|
|
Figure 2
At this point, the thermostat will be fully functional; its de- fault temperature setpoint (not shown) is 70°F. At this point, if the equipment has been fully powered and if a heat demand were present, the system would begin operating.
NOTE − Temperature scale default is Fahrenheit units but may be reset to show Celsius, if desired. See page 8.
Buttons, Backlight, Timers & Settings
Buttons are located behind the small door on the right− hand side of the thermostat (see figure 3).
IMPORTANT
Do NOT begin pressing buttons until after you read the following section describing each button.
A pale blue display backlight illuminates for 30 seconds each time any button is pressed.
When PROG or DAY/TIME button is pressed, a field be- gins flashing, expecting another input. Start making changes within 15 seconds or the HOME screen will re- turn.
Thermostat Buttons |
| |
Heat | Cool |
|
Prog | Auto |
|
Copy Day/Time |
| |
Fan | Hold | (DOOR |
|
| |
|
| OPEN) |
Settings Enter |
| |
| (Outside) |
|
Figure 3
When an Arrow, HOLD, HEAT, or COOL button is pressed, SETPOINT and the temperature setting appears for 15 seconds. If desired, start making changes within 15 sec- onds or the HOME screen will return. The backlight will turn off 15 seconds after the HOME screen reappears.
DAY/TIME − Setting the Day and Time
Press the DAY/TIME button and set the CURRENT hour, minute, and day of week as follows:
1.AM12" will flash on the screen. Press the UP/DOWN arrows to change the hour. (
spond to time of day.) Press DAY/TIME OR, if adjust- ing for daylight savings time, pressing the ENTER but- ton stores the single change and exits to the HOME screen, bypassing minutes and day of week.
2.Minutes will flash. Use the UP/DOWN arrow button to display the minutes past the hour. Press DAY/TIME.
3.Day
buttons to display the current day. Day selections are abbreviated as
and Y/TIME.
4.The HOME screen reappears; confirm day and time are correct. This completes day and time setting.
Page 2
505068M 07/05
