Lenovo 4219, 4220, 4222, 4215 Completing the parts replacement, What to do next, Mouse connectors

3.Disconnect the old mouse cable from the computer.

Note: Your mouse might be connected to a PS/2 mouse connector 1 or a USB connector 2. Depending on where your mouse is connected, see “Locating connectors on the rear of your computer” on page 8 or “Locating connectors on the front of your computer” on page 7.

Figure 33. Mouse connectors

4.Connect a new mouse cable to the appropriate connector on the computer.

What to do next:

vTo work with another piece of hardware, go to the appropriate section.

vTo complete the replacement, go to “Completing the parts replacement.”

Completing the parts replacement

After completing the installation or replacement for all parts, you need to reinstall the computer cover and reconnect cables. Depending on the parts you installed or replaced, you might need to confirm the updated information in the Setup Utility program. Refer to Chapter 4, “Using the Setup Utility program,” on page 53.

To reinstall the computer cover and reconnect cables to your computer, do the following:

1.Make sure that all components have been reassembled correctly and that no tools or loose screws are left inside your computer. See “Locating components” on page 10 for the locations of various components in your computer.

2.If you have removed the front bezel, reinstall it. See “Removing and reinstalling the front bezel” on page 15.

3.Make sure that the cables are routed correctly before reinstalling the computer cover. Keep cables clear of the hinges and sides of the computer chassis to avoid interference with reinstalling the computer cover.

40User Guide