9.To install the memory cooler, secure the rear of the memory cooler with the retaining clips of the memory slots and then pivot the memory cooler downward until it snaps into position. Reconnect the memory fan cable to the system board. See “Locating parts on the system board” on page 11.
Figure 19. Installing the memory cooler
What to do next:
•To work with another piece of hardware, go to the appropriate section.
•To complete the installation or replacement, go to “Completing the parts replacement” on page 55.
Installing or replacing the optical drive
Attention: Do not open your computer or attempt any repair before reading and understanding the “Important safety information” on page v.
This section provides instructions on how to install or replace the optical drive.
To install or replace an optical drive, do the following:
1.Turn off the computer and disconnect all power cords from electrical outlets.
2.Remove the computer cover. See “Removing the computer cover” on page 30.
3.Remove the front bezel. See “Removing and reinstalling the front bezel” on page 30.
4.Depending on whether you are installing or replacing an optical drive, do one of the following:
•If you are installing a secondary optical drive, remove the plastic panel in the front bezel for the drive bay you want to use. If there is a metal static shield installed in the drive bay, remove the metal static shield.
Chapter 5. Installing or replacing hardware 37
