• To complete the installation or replacement, go to “Completing the parts replacement” on page 55.

Installing or replacing a hard disk drive

Attention: Do not open your computer or attempt any repair before reading and understanding the “Important safety information” on page v.

This section provides instructions on how to install or replace a hard disk drive.

Note: If you are installing a SAS hard disk drive, you must ensure that the SAS hard disk drive enablement module (one to three hard disk drives) or the LSI MegaRAID SAS adapter card is installed.

To install or replace a hard disk drive, do the following:

1.Turn off the computer and disconnect all power cords from electrical outlets.

2.Remove the computer cover. See “Removing the computer cover” on page 30.

3.Locate the hard disk drive. See “Locating internal drives” on page 12.

4.Disconnect the signal cable and the power cable from the hard disk drive.

5.Gently press the two tabs of the hard disk drive bracket toward each other and then pull the bracket handle out to remove the hard disk drive from the chassis.

Figure 24. Removing a hard disk drive

6. Gently flex the sides of the bracket to remove the hard disk drive from the bracket.

40ThinkStation User Guide

Page 52
Image 52
Lenovo 569, 568, 606, 567 manual Installing or replacing a hard disk drive, Removing a hard disk drive