Lenovo 567, 569, 568, 606 manual Troubleshooting and diagnostics, Basic troubleshooting

Models: 567 606 569 568

1 134
Download 134 pages 58.35 Kb
Page 95
Image 95

Chapter 11. Troubleshooting and diagnostics

This chapter describes some basic troubleshooting and diagnostic programs. If your computer problem is not described here, see Chapter 12 “Getting information, help, and service” on page 101 for additional troubleshooting resources.

Basic troubleshooting

The following table provides information to help you troubleshoot your computer problems.

Note: If you cannot correct the problem, have the computer serviced. For a list of service and support telephone numbers, refer to the ThinkStation Safety and Warranty Guide that comes with your computer or go to the Lenovo Support Web site at http://www.lenovo.com/support/phone.

Symptom

Action

 

 

The computer does not start

Verify that:

when you press the power

• The power cord is correctly connected to the rear of the computer and to a

switch.

working electrical outlet.

 

 

• If your computer has a secondary power switch on the rear of the computer,

 

make sure that it is switched on.

 

• The power indicator on the front of the computer is on.

 

• The computer voltage matches the voltage available at the electrical outlet for

 

your country or region.

 

 

The monitor screen is blank.

Verify that:

 

• The monitor signal cable is correctly connected to the monitor and to the

 

appropriate monitor connector on the computer.

 

• The monitor power cord is correctly connected to the monitor and to a working

 

electrical outlet.

 

• The monitor is turned on and the brightness and contrast controls are set

 

correctly.

 

• The computer voltage matches the voltage available at the electrical outlet for

 

your country or region.

 

• If your computer has two monitor connectors, be sure to use the connector

 

on the graphics card.

 

 

The keyboard does not work.

Verify that:

 

• The computer is turned on.

 

• The keyboard is securely connected to a USB connector on the computer.

 

• No keys are stuck.

 

 

The mouse does not work.

Verify that:

 

• The computer is turned on.

 

• The mouse is securely connected to a USB connector on the computer.

 

• The mouse is clean. Refer to “Optical mouse” on page 81 for further information.

 

 

© Copyright Lenovo 2012

83

Page 95
Image 95
Lenovo 567, 569, 568, 606 manual Troubleshooting and diagnostics, Basic troubleshooting