Setting up Your
Enabling Jumbo Frames for Each NIC
You can enable jumbo frames for each NIC in your
Jumbo frame support should only be enabled if you are sure your network is
VLAN
Each NIC in your
Manually Configuring Network Settings
There are various settings in the network setup that you can manually configure.
1.Click Modify network settings.
2.Uncheck Automatically configure DNS, WINS, and all IP addresses (DHCP).
3.DNS Servers — enter the IP addresses of the DNS (Domain Name System) servers. DNS is used for translating the domain name to IP addresses.
4.WINS Servers — enter the IP addresses of the WINS server.
5.From the Bonding Mode
●Transmission Load Balance — increases bandwidth by distributing the load across multiple NICs.
●Link Aggregation — increases bandwidth by distributing the load across multiple ports in a switch. Link Aggregation requires an 802.3ad compatible switch.
●Failover — provides recovery from a failure, so if one NIC should fail, your system still has network connectivity with the other NIC.
6.To connect your
7.Click Apply to save your settings.
8.If a DHCP server is unavailable for a network interface card (NIC), the device could
9.You can change the following settings in the Information section:
●IP Address — the static IP address of the
●Subnet Mask — the subnet that the IP address belongs to. The default value is 255.255.255.0.
●Gateway — enter the gateway IP address in this field.
10.Click Apply to save your settings.
Connecting
7
the