Table
Problem | Solution |
|
|
The image is blurred. | v Adjust the Focus on the projector. |
| v Press the |
| the projector. |
| v Ensure the |
| range specified. |
| v Check that the projector lens is clean. |
| v Make sure the output resolution from the PC is 1024 |
| x 768, the native resolution of the projector. |
|
|
The image is wider at the top or | v Position the projector so it is as perpendicular to the |
bottom (trapezoid effect). | screen as possible. |
| |
| v Use the Keystone button on the remote control or |
| projector to correct the problem. |
|
|
The image is reversed or upside | Check the Projection setting on the Setup menu of the |
down. | OSD. |
|
|
The image is streaked. | v Set the Frequency and Tracking settings on the Setup |
| menu of the OSD to the default settings. |
| v To ensure the problem is not caused by a connected |
| PC’s video card, connect to another computer. |
|
|
The image is flat with no contrast. | Adjust the Contrast setting on the Quality menu of the |
| OSD. |
|
|
The color of the projected image | Adjust the Color Temp. and Gamma settings on the |
does not match the source image. | Quality menu of the OSD. |
|
|
There is no light from the | v Check that the power cable is securely connected. |
projector. | v Ensure the power source is good by testing with |
| |
| another electrical device. |
| v Restart the projector in the correct order and check |
| that the Power LED is green. |
| v If you have replaced the lamp recently, try resetting |
| the lamp connections. Make sure the lamp cover is |
| flush with the projector case when closed. |
| v Replace the lamp module. “Replacing the projector |
| lamp” on page |
| v Put the old lamp back in the projector and have the |
| projector serviced. |
|
|
The lamp goes off. | v Power surges can cause the lamp to turn off. Press |
| the Power button twice to turn off the projector. |
| When the Lamp Ready LED is on, press the Power |
| button. |
| v Replace with a new lamp module.“Replacing the |
| projector lamp” on page |
| v Put the old lamp back in the projector and have the |
| projector serviced. |
|
|
