Lenovo W700ds manual Error messages, Message Solution

Error messages

Note:

1.In the charts, x can be any character.

2.The version of PC-Doctor referred to here is PC-Doctor for Windows.

Message	Solution
0176: System	This message is displayed if you remove the Security Chip and
Security - The	reinstall it, or install a new one. To clear the error, enter the
System has been	BIOS Setup Utility. If this does not solve the problem, have the
tampered with.	computer serviced.
0182: Bad CRC2.	Checksum of the CRC2 setting in the EEPROM is not correct.
Enter BIOS Setup	Press F1 to enter the BIOS Setup Utility. Press F9 and then
and load Setup	Enter to load the default setting. Press F10 and then Enter to
defaults.	restart the system.
0185: Bad startup	Checksum of the startup sequence setting in the EEPROM is
sequence settings.	not correct. Press F1 to enter the BIOS Setup Utility. Press F9
Enter BIOS Setup	and then Enter to load the default setting. Press F10 and then
and load Setup	Enter to restart the system.
defaults.
0190: Critical	The computer turned off because the battery is low. Connect
low-battery error	the AC adapter to the computer and charge the battery, or
	replace the battery with a fully charged one.
0191: System	The system configuration change has failed. Confirm the
Security - Invalid	operation and try again. To clear the error, enter the BIOS
remote change	Setup Utility.
requested.
0199: System	This message is displayed if you enter a wrong supervisor
Security - Security	password more than three times. Confirm the supervisor
password retry	password and try again. To clear the error, enter the BIOS
count exceeded.	Setup Utility.
01C8: More than one	Remove one of the Modem Daughter Cards. Otherwise, press
modem devices are	Esc to ignore the warning message. If this does not solve the
found. Remove one	problem, have the computer serviced.
of them. Press <Esc>
to continue.
01C9: More than one	Your ThinkPad computer has a built-in Ethernet feature, and
Ethernet devices are	you cannot add another such feature by installing an Ethernet
found. Remove one	device such as a Mini-PCI Ethernet Card or an Ethernet
of them. Press <Esc>	Daughter Card. If this error message is displayed, remove the
to continue.	Ethernet device that you installed. Otherwise press Esc to
	ignore the warning message. If this does not solve the problem,
	have the computer serviced.

Chapter 3. Solving computer problems 13