Message

Solution

 

 

The power-on

A power-on password or a supervisor password is set. Type

password prompt

the password and press Enter to use the computer. If the

 

power-on password is not accepted, a supervisor password

 

might have been set. Type the supervisor password and press

 

Enter. If you still see the same error message, have the

 

computer serviced.

 

 

The hard disk

An HDD or SSD password is set. Type the password and press

password prompt

Enter to use the computer.

 

If you still see the same error message, have the computer

 

serviced.

 

 

Hibernation error

The system configuration changed between the time your

 

computer entered hibernation mode and the time it left this

 

mode, and your computer cannot resume normal operation.

 

v Restore the system configuration to what it was before your

 

computer entered hibernation mode.

 

v If the memory size has been changed, re-create the

 

hibernation file.

 

 

Operating system

Verify the following:

not found.

v The HDD or SSD is correctly installed.

 

v A startable disc is in the drive

 

If you still see the same error message, check the boot

 

sequence, using the BIOS Setup Utility.

 

 

EMM386 Not

Edit C:\CONFIG.SYS and change a line from

Installed - Unable to

device=C:\WINDOWS\EMM386.EXE RAM

Set Page Frame Base

 

Address.

to

 

 

device=C:\WINDOWS\EMM386.EXE NOEMS

 

and save this file.

 

 

CardBus

Enter the BIOS Setup Utility. Press F9 and then Enter to load

Configuration Error -

the default setting.

Device Disabled

Press F10 and then Enter to restart the system.

 

 

 

16ThinkPad® W700 and W700ds Service and Troubleshooting Guide

Page 24
Image 24
Lenovo W700ds manual Message Solution