Message | Solution |
|
|
Cannot boot from | Check the status of the device which you want to boot from. |
any device. | Device not found |
| |
| Check the device you want to boot from. |
| Device error |
| Check the device you want to boot from. |
| No valid operating system |
| Check that the operating system has no failure and is |
| installed correctly. |
| Excluded from boot order |
| Open the BIOS Setup Utility and add the device to boot |
| order. |
|
|
|
|
Beep errors |
|
|
|
One short beep, | If you install a memory module in only one of the two |
pause, three short | memory slots, make sure that it is correctly installed in the slot |
beeps, pause, three | indicated as |
more short beeps, | of the slots, make sure that they are installed correctly. If they |
and one short beep | are, and you still hear the beeps, have the computer serviced. |
|
|
One long and two | The video function has a problem. Have the computer |
short beeps | serviced. |
|
|
Four cycles of four | The Security Chip has a problem. Have the computer serviced. |
short beeps |
|
|
|
Five beeps | The system board has a problem. Have the computer serviced. |
|
|
If one of the following error code messages is displayed on the screen, have the computer serviced:
0175: Bad CRC1, stop POST task
0177: Bad SVP data, stop POST task. Checksum of the supervisor password in the EEPROM is not correct.
0187: EAIA data access error
0188: Invalid RFID serialization information area
0189: Invalid RFID configuration information area
0192: System Security - Embedded Security hardware tamper detected.
0260: System timer error
0270: Real time clock error
02D0: System cache error
Chapter 3. Solving computer problems 17
