DVD1 DD D 5.1 L7 FILM
VOL -30dB

SDP-40

Getting Started

The MENU arrows navigate through all menus when the MAIN command bank is active (see page 2-8 for more information about command banks). Press the up and down MENU arrows to scroll through menu items. A scroll bar will appear on the right side of the screen when these items exceed the on-screen margins. Press the right MENU arrow to select the highlighted item. Press the left MENU arrow to exit the current menu.

TWO-LINE STATUS

The two-line status (pictured at the right) appears on the on-screen display whenever

the unit receives a command or whenever

the input type changes, unless the STATUS parameter on the ON-SCREEN DISPLAY menu is set to OFF (see page 3-31). Pressing the STAT button on the remote control will also display the two-line status. The two-line status that appears depends on which remote control command bank is active (see page 2-8).

The two-line status shows the current input name (top-left); the current listening mode name (bottom-left); the current input type (top-center); and the current volume level (right).

RESTORING FACTORY-DEFAULT SETTINGS

The procedure below outlines the process to restore factory-default settings. Before performing these steps, record custom settings on the installation worksheet (see page A-12). All parameters will be reset to their factory-default value. This procedure should be performed before setup begins.

To restore factory-default settings:

1.Record user-defined settings on the installation worksheet (see page A-12).

2.If the unit is on, place it into standby by pressing the

(standby) button on the remote control. If the unit is in standby, skip ahead to Step 3.

3.Power the unit on by pressing the@@@((standby) button on the remote control.

4.Quickly press and hold the MUTE button on the remote control until the following hidden menu appears:

FACTORY SETTINGS

EXIT

RESTORE DEFAULTS

The MUTE button must be pressed within 3s of powering the unit on. If the message “MUTE ON” appears in the top- left corner of the screen when the MUTE button is pressed, too much time has passed. Begin again with Step 2.

5.Use the up and down MENU arrows to highlight RESTORE DEFAULTS, then press the right MENU arrow to restore factory-default settings. (Selecting the EXIT option with the right MENU arrow will cancel the restoration of factory- default settings.)

6.The message “FACTORY SETTINGS HAVE BEEN RESTORED” will appear on the screen. Press any front panel or remote control button to restart the unit.

1-5

Page 16
Image 16
Lexicon SDP-40 manual TWO-LINE Status, Restoring FACTORY-DEFAULT Settings, Exit