Information
Replacing the Lamp
1 Turn off the projector and unplug the power cable. Carefully place on a cushioned surface.
(Allow the lamp to cool for 1 hour before removing the used lamp from the projector.)
After lifting the lamp cover off, remove the two
3 retaining screws on the lamp case with a screw- driver.
Screws 
5 Pullcase.out the handle slowly and remove the lamp
7 Tighten the screws you removed in step 3.
(Make sure they are fixed firmly.)
2 Unscrew the screw from the lamp cover using a screwdriver.
Lamp case screw
4 Lift the lamp up from the projector.
bottom
Knob
Insert the new lamp gently into the correct position.
6 Pushinstalled.the lamp bottom to check if it is correctly
Close the lamp cover and install the screws from
8 step 2 to install the cover.
(If the lamp cover is not installed correctly the unit will not
power on.)
Using another manufacturers lamp may cause damage to the projector or lamp.
Make sure the lamp cover is securely fastened. If the lamp cover is not installed correctly the unit will not power on. If this fault persists contact an LG Authorized Service Center.
33
