MAINTENANCE
REMOVING &REPLACING THE STORAGE DRAWER
To Remove Storage Drawer:
1.CAUTION - Turn power OFF before removing the Stroage Drawer.
2.Open the drawer to the fully opened position.
3.Remove the 2 screws (right and left sides). (refer to the drowing below)
4.Locate glide lever on each side of drawer, push down on the left glide lever and pull up on the right glide lever.
5.Pull the Stroage Drawer away from the range.
WARNING
•Turn POWER OFF before removing the Warming Drawer.
-Failure to do so can result in severe personal injury,death or electrical shock.
Remove screw | |
Lever | Lever |
|
To Replace the Storage Drawer:
1.Replace shield on the right glide of the drawer body.
2.Pull the bearing glides to the front of the chassis glide.
3.Align the glide on each side of the drawer with the glide slots on the range.
4.Push the drawer into the range until levers click (approximately 2 inches). Pull the drawer open again to seat bearing glides into position. If you do not hear the levers click or the bearing glides do not feel seated, remove the drawer and repeat steps
This will minimize possible damage to the bearing glides.
OVEN VENT
The oven vent is located above the left rear surface unit. This area could become hot during oven use.
It is normal for steam to come out of the vent.
The vent is important for proper air circulation. Never block this vent.
English
Español
Push down with finger | Pull up with finger |
- 27 -