LG Electronics LRG3093ST manual Before Calling For Service, T Ro U B L E S H O Ot I N G, English

T RO U B L E S H O OT I N G

BEFORE CALLING FOR SERVICE

Problem	Possible	Causes	Solutions
Broil or self-clean	• The oven temperature is too high.		• Allow the oven to cool below locking temperature.
doesn’t work			• This can take up to 1 hr after the cycle is complete.
Oven not clean after a	• Improper oven controls setting.		• See the Using the “USING THE SELF-CLEANING
self-clean cycle			OVEN” section.
	• The oven was heavily soiled.
			• Clean up heavy spillovers before beginning the
			self- clean cycle. Heavily soiled ovens may need to
			self-clean again or for a longer period of time.
“CLOSE DOOR TO	• The broil or self-clean cycle has		• Close the oven door.
CONTINUE BROILING”	been selected but the door is not
or “DOOR OPENED”	closed.
appears in the display
“DOOR LOCKED” light	• The oven door is locked because the		• Touch the “CLEAR OFF” pad. Allow the oven to
is on when you want to	temperature inside the oven has not		cool.
cook	dropped below the locking
	temperature.
Oven control beeps	• You have “F3”.		• Touch the “CLEAR OFF” pad. Allow the oven to
and displays any F			cool for one hour. Put the oven back into
code error.			operation.
	• You have “F11”.		• Check the main gas shut-off valve or the oven gas
			shut-off valve(see “Surface burners light but oven
			burner does not” column).
	• If the function code repeats.		• Disconnect all power to the range for 5 minutes
			and then reconnect power. If the function error
			code repeats, call for service.
Oven racks are	• The oven racks were cleaned in a		• Apply a small amount of vegetable oil to a paper
difficult to slide	self-clean cycle.		towel and wipe the edges of the oven racks with
			the paper towel. Do not use lubricant sprays.
Power outage, clock	• Power outage or surge.		• Reset the clock. If the oven was in use, you must
flashes			reset it by touching the “CLEAR OFF” pad,
			setting the clock and resetting any cooking
			function.
“Burning” or “oily”	• This is normal in a new oven and		• To speed the process, set a self-clean cycle for a
odor emitting from the	will disappear in time.		minimum of 3 hours. See the “USING THE SELF-
vent			CLEANING OVEN” section.
Strong odor	• An odor from the insulation around		• This is temporary.
	the inside of the oven is normal for
	the first few times the oven is used.

ENGLISH

35