LG Electronics LST-4200A Connections Antenna Connections, TV or Other Device Connection Panel

Connections

Antenna Connections

1Connect the “Antenna” to the “ANT IN” jack on the HDTV Receiver using a coaxial RF cable.

ote

There might be some areas where the signal strength could be too high. If so, you may need to connect the antenna to an attenuator. Screw the attenuator onto the “ANT IN” jack.

2 Connect the “ANT LOOP OUT” jack from the HDTV Receiver to the “Antenna In” jack on your TV using a coaxial RF cable.

							Antenna
TV or Other Device Connection Panel
ANTENNA	S-VIDEO	COMPONENT VIDEO INPUT			VIDEO	AUDIO INPUT
INPUT	INPUT				INPUT
		Pr	Pb	Y	L	L	OR
							R

Cable TV

Wall Jack Panel

OR

Attenuator (Not supplied)

HDTV Receiver Connection Panel

ip

Before Connecting Your Antenna

During initial installation and setup of your HDTV Receiver, you may need to install a 10 dB attenuator to the Antenna input “ANT IN” on the LST-4200A. The LST-4200A is a high performance, high-gain system intended for operation under normal and weak signal conditions, providing the best reception with its optimum gain. However, there might be some reception areas where the signal strength is too high (e.g. due to close proximity to an unde- sirable signal or transmitter), so you need an attenuator that lowers the incoming signal strength (from the undesir- able transmitter) to more normal levels. This 10 dB attenuator should be used only in a reception area where the undesired signal strength is too high.

10