LG Electronics LST-4200A owner manual Connections HD Monitor Component YPbPr Connections

Connections (Continued)

HD Monitor Component (YPbPr) Connections

Antenna

OR

Cable TV

Wall Jack Panel

HD Ready TV Connection Panel

ANTENNA	COMPONENT VIDEO INPUT			AUDIO INPUT		VIDEO
INPUT						INPUT
	Pr	Pb	Y	L	R

To AUDIO OUT

HDTV Receiver Connection Panel

1Connect the “Antenna/Cable” to the “ANT IN” jack on the HDTV Receiver using a coaxial RF cable.

ote

There might be some areas where the signal strength could be too high. If so, you may need to connect the antenna to an attenuator. Screw the attenuator onto the “ANT IN” jack. (Refer to page 10.)

2 Connect the “ANT LOOP OUT” jack from the HDTV Receiver to the “Antenna In” jack on your TV using a coaxi- al RF cable.

3using RCA-type cables. (The Output Selection must be set to YPbPr, refer to Display Format Setup on page

17.)Connect the “COMPONENT OUT” jacks from the HDTV Receiver to the “COMPONENT IN” jacks on your TV

4 Connect the L/R “AUDIO OUT” jacks from the HDTV Receiver to the L/R “AUDIO IN” jacks on your TV using RCA-type cables.

ote

1080i, 720p, 480p, and 480i modes are available for component video (YPbPr) outputs.

12