LG Electronics LST-4200A owner manual Connections HD Monitor RGB Connections

Connections (Continued)

HD Monitor RGB Connections

Antenna

Cable TV

Wall Jack Panel

HD Ready TV Connection Panel

ANTENNA	S-VIDEO	RGB INPUT	VIDEO	AUDIO INPUT
INPUT	INPUT		INPUT
				L	R

INSTALLATION

OR

To AUDIO OUT

HDTV Receiver Connection Panel

11 Connect the “Antenna/Cable” to the “ANT IN” jack on the HDTV Receiver using a coaxial RF cable.

ote

There might be some areas where the signal strength could be too high. If so, you may need to connect the antenna to an attenuator. Screw the attenuator onto the “ANT IN” jack. (Refer to page 10.)

2 Connect the “ANT LOOP OUT” jack from the HDTV Receiver to the “Antenna In” jack on your TV using a coaxi- al RF cable.

3 Connect the “RGB OUT” jack from the HDTV Receiver to the “RGB IN” jack on your TV using VGA-type connec- tor. (The Output Selection must be set to RGB, refer to Display Format Setup on page 17.)

4 Connect the L/R “AUDIO OUT” jacks from the HDTV Receiver to the L/R “AUDIO IN” jacks on your TV using RCA-type cables.

ote

1080i, 720p, and 480p modes are available for RGB outputs.

13