LG Electronics WG1805RY6, WG2405RY6, RAD-183A, RAD-243A service manual Cabinet Installation

Installation

Cabinet Installation

1. Open the window. Mark a line on the center of the
window stool between the side window stop mold-	Sill
ings.	Bracket
Loosely attach the sill bracket to the support bracket	Carriage
using the carriage bolt and the lock nut.
	Bolt
	(M-Screw)

Support Bracket

Lock nut

Figure 6

2.Attach the sill bracket to the window sill using the screws (Type B).

Carefully place the cabinet on the window stool and align the center mark on the bottom front with the center line marked window stool.

Cabinet

Track hole

Support

Bracket

Carriage bolt and lock nut

Machine screw(Type D) and lock nut

Outer edge of window sill

Screw(Type B) Sill bracket

Figure 7

3.Using the M-screw and the lock nut, attach the sup- port bracket to the cabinet track hole. Use the first track hole after the sill bracket on the outer edge of the window sill. Tighten the carriage bolt and the lock nut. Be sure the cabinet slants outward.

CAUTION: Do not drill a hole in the bottom pan. The unit is designed to operate with approximately 1/2" of water in bottom pan.

4.Pull the bottom window sash down behind the Top retainer bar until they meet.

NOTICE

1.Do not pull the window sash down so tightly that the movement of Frame curtain is restricted. Attach the cabinet to the window stool by driving the screws (Type B) through the cabinet into window stool.

2.The cabinet should be installed with a very slight tilt downward toward the outside.

Top
retainer
bar	Window stool
Front angle	Figure 8
Window sash Top retainer bar
Foam-PE
Cabinet
Frame curtain
Foam-PE
	Figure 9
	Sash track

Front Angle

Screw(Type B)

Figure 10

11Room Air Conditioner