Life Fitness 95CE operation manual Setup, Electrical Power Requirements

1.3SETUP

Read the entire Operation Manual before setting up the Lifecycle Upright Bike.

ELECTRICAL POWER REQUIREMENTS

The Lifecycle Upright Bike requires an AC power supply according to the electrical configurations listed in the chart below.

Supply Voltage	Frequency	Rated Current
(VAC)	(Hz)	(Amps)
100	50 / 60	1.6
110	50 / 60	1.6
120	50 / 60	1.6
200	50 / 60	.8
220	50 / 60	.8
230	50 / 60	.8
240	50 / 60	.8

NOTE: Do not modify the plug provided with this product. If the plug does not fit into an available electrical outlet, have a proper outlet installed by a qualified electrician.

WHERE TO PLACE THE LIFECYCLE® UPRIGHT EXERCISE BIKE

Following all safety instructions in Section 1.1, move the bike to the location in which it will be used. See Section 7, titled Specifications, for the dimensions of the product footprint (assembled dimensions). Allow a distance of 8 to 12 inches, or 21 to 30 centimeters, between the bike and other objects or surfaces on either side. Allow a distance of 3 feet, or 1 meter, from the front or rear of the bike to any other object or surface.

HOW TO STABILIZE THE LIFECYCLE UPRIGHT EXERCISE BIKE

After placing the bike in position, check the unit’s stability by attempting to rock it from side to side. Any slight rocking indicates that the unit must be leveled. Determine which foot is not

resting completely on the floor. Loosen the jam nut (A) with an open-end 9/16-inch wrench, and rotate the stabilizing foot (B) to lower it. Verify that the bike is stable, and repeat the adjustment as neces- sary until the unit no longer rocks. Lock the adjustment by tightening the jam nut against the stabilizer bar.

8