Lincoln Electric F355I manual Error Codes for the Power Wave, Error Code # Indication

E-3	TROUBLESHOOTING	E-3
	Observe all Safety Guidelines detailed throughout this manual

ERROR CODES FOR THE POWER WAVE

The following is a list of possible error codes that the POWER WAVE F355i (CE) can output via the status light (see "Troubleshooting the Power Wave / Power Feed System Using the Status LED." If connected to a PF-10/11 these error codes will generally be accompanied by an "Err 006" or "Err 100" on the user interface display.

		Error Code #	Indication
11		CAN communication bus off.	Probably due to excessive number of communication errors.
12		User Interface time out error.	UI is no longer responding to the Power Source. The most likely
			cause is a fault/bad connection in the communication leads or con-
			trol cable.
21		Unprogrammed Weld Mode.	Contact the Service Department for instructions on reloading the
			Welding Software.
	22	Empty Weld Table.	Contact the Service Department for instructions on reloading the
			Welding Software.
23		Weld Table checksum error.	Contact the Service Department for instructions on reloading the
			Welding Software.
31		Primary overcurrent error.	Excessive Primary current present. May be related to a short in the
			main transformer or output rectifier.
32		Capacitor "A" under voltage	Low voltage on the main capacitors. May be caused by improper
			input configuration.
33		Capacitor "B" under voltage	When accompanied by an overvoltage error on the same side, it
			indicates no capacitor voltage present on that side, and is usually
			the result of an open or short in the primary side of the machine.
34		Capacitor "A" over voltage	Excess voltage on the main capacitors. May be caused by improp-
			er input configuration.
35		Capacitor "B" over voltage	When accompanied by an under voltage error on the same side, it
			indicates no capacitor voltage present on that side, and is usually
			the result of an open or short in the primary side of the machine.
36		Thermal error	Indicates over temperature. Usually accompanied by Thermal LED.
			Check fan operation. Be sure process does not exceed duty cycle
			limit of the machine.
37		Soft start error	Capacitor precharge failed. Usually accompanied by codes 32-35.
41		Secondary overcurrent error	The secondary (weld) current limit has been exceeded. When this
			occurs the machine output will phase back to 100 amps, typically
			resulting in a condition referred to as "noodle welding"
			NOTE: The secondary limit is 570 amps for the standard stud, and
			325 amps for all single phase operation.
43		Capacitor delta error	The maximum voltage difference between the main capacitors has
			been exceeded. May be accompanied by errors 32-35.
	Other		Error codes that contain three or four digits are defined as fatal
			errors. These codes generally indicate internal errors on the
			Control Board. If cycling the input power on the machine does not
			clear the error, try reloading the operating system. If this fails,
			replace the control board.

CAUTION

If for any reason you do not understand the test procedures or are unable to perform the tests/repairs safely, contact your Local Lincoln Authorized Field Service Facility for technical troubleshooting assistance before you proceed.

POWER WAVE F355i (CE)