Lincoln Electric IM644-A Connection Diagram, Remote Control, Electrode Cable, To Wire Feed Unit

COMMANDER / LN-7 CONNECTION DIAGRAM

WARNING

Do not operate with panels open.	Keep guards in place.
Disconnect NEGATIVE (-) BATTERY LEAD	Keep away from moving parts.
before servicing.	Only qualified personnel should install,use
Do not touch electrically live parts.	or service this equipment.

CONNECTION DIAGRAM:

F-4

COMMANDER 500

6PIN AMPHENOL

14PIN AMPHENOL

TO LN-7 INPUT

CABLE PLUG

K584 OR K594 CONTROL CABLE	OPTIONAL K857
	OR K857-1
	REMOTE CONTROL

ELECTRODE TO WORK

TO WORK

DIAGRAMS

	ELECTRODE CABLE
CAUTION :	TO WIRE FEED UNIT

ANY INCREASE OF THE HIGH IDLE ENGINE RPM BY CHANGING THE GOVERNOR SETTING OR OVERRIDING THE THROTTLE LINKAGE WILL CAUSE AN INCREASE IN THE THE AC AUXILIARY VOLTAGE. IF THIS VOLTAGE GOES OVER 140 VOLTS, WIRE FEEDER CONTROL CIRCUITS MAY BE DAMAGED. THE ENGINE GOVERNOR SETTING IS PRE-SET AT THE FACTORY - DO NOT ADJUST ABOVE RPM SPECIFICATIONS LISTED IN

THE ENGINE WELDER OPERATING MANUAL.

N.A. USE VOLTMETER SWITCH TO SELECT DESIRED ELECTRODE POLARITY. POSITION THE SELECTOR SWITCH TO "WIRE WELDING CV".

N.B. WELDING CABLES MUST BE OF PROPER CAPACITY FOR THE CURRENT AND DUTY CYCLE OF IMMEDIATE AND FUTURE APPLICATIONS. SEE OPERATING MANUAL.

N.C. IF OPTIONAL REMOTE OUTPUT CONTROL IS USED, PLACE LOCAL REMOTE SWITCH IN "REMOTE" POSITION.

7-21-98

S23987

F-4