Lincoln Electric IM 513-B manual

23)Drive three (3) self-tapping screws into output panel. (5/16” Nut driver or socket wrench). NOTE: The CV outout terminal assembly mounts under the weld output terminals on all machines.

24)With the CC/CV switch set to CC, start the engine and check the open circuit voltage on the output terminals. The voltage should be 80 to 100 volts with the thermostat and range switch set at maxi- mum. NOTE: OCV may be slightly higher when the unit is cold. (Voltmeter)

25)Switch the CC/CV switch to CV and check the voltage between the Positive output terminal and the CV output terminal. The voltage should be 45 to 55 volts at maximum output position and 7 to 12 volts at minimum output position. (Voltmeter)

26)(For Classic II’s only) Reassemble the side panel. (3/8” Socket wrench)

– 15 –