OPERATIONB-5
Repressing the Auto Key sets the recommended pro- cedure for the metal thickness displayed.
MANUAL KEY
Permits individual setting of wire feed speed and arc voltage for manual procedure setup. The manual screen displays wire feed speed, arc voltage, and a cursor that indicates which parameter, wire feed speed, or arc voltage is being controlled by the thumb- switch on the
Left arrow keys — Do not function in Manual mode.
Center arrow keys — Increase (up arrow) or decrease (down arrow) wire feed speed.
Right arrow keys — Increase (up arrow) or decrease (down arrow) arc voltage.
If the spot or stitch timers are on it will be indicated in the bottom left corner of the display. (See Figures 6 and 7 below.)
TYPICAL MANUAL KEY PRESS SEQUENCE
MEMORY KEYS
SAVE KEY
Saves present setup (including process, procedure, and timer functions, if used) to one of five memories chosen by pressing the desired memory number key.
When the Save key is pressed, a prompting message instructing the operator to “PRESS MEMORY
The six arrow keys perform no function when saving a setup.
NOTE: When a setup is saved to a memory, the previ- ous content of that memory is lost because it is replaced by the present setup. Removing input power does not affect setups In memory.
TYPICAL SAVE KEY PRESS SEQUENCE
Auto screen displayed prior to pressing Save key. Save key is pressed, and display changes to prompt- ing message. Memory 1 key is pressed, and the dis- play changes to a message that confirms the setup was saved to memory 1. The message is displayed for 2.5 seconds, and then the original Auto screen is displayed.
Figure 6 | Figure 7 |
Auto screen is being displayed prior to pressing Manual key. The Manual key is pressed, the Manual screen is now displayed. The procedure is the same that was in Auto.
MEMORY NUMBER KEY
Pressing the desired Memory Number key recalls the setup saved in that memory (including process, proce- dure, and timer functions if used).
IDEALARC
